One of the important components of the most modern engines are the spark-plugs. These components are subjected to a lot of stress and should be checked periodically and replaced when needed. These components can be easily replaced with little care and some tools, the method is quick and straightforward but also a methodical procedure.

Replacing them will definitely be a rewarding task an individual can perform. It is a fairly simple and easy task and it takes only 40 minutes for a V8. Follow the directions.

Tools Needed

- 3/16 or 5/8 deep socket
- 3? and 6? drive extensions
- Swivel adapter for the driver allows for tight spaces
- Socket Driver

Directions

Step 1:
Before starting the work, consult a repair or service manual for the particular model and make of your vehicle.

Step 2:
Before you begin, Make sure that the car engine is turned off.

Step 3
Grip the plug wire boot without the wire for removing one spark-plug wire from one spark-plug. Using a spark-plug wire puller will be better if available.

Step 4:
The spark-plug should not have any oil or dirt around it. If needed, wipe clean the area around the spark plug hole. Be sure not to brush away the oil and dirt from the hole.

Step 5:
For taking out the plug, only use proper tools. The plug has to be turned anti-clockwise to the left. A 5/8 or 13/16 deep socket is the appropriate tool for this task. You may also need a swivel joint and an extension.

Step 6:
Replace the plug with a new one and turn by hand until it is tightened.

Step 7:
For fitting in the new one, use the same tool that was used for taking out the old one.

Step 8:
Connect the spark plug wire to the new plug and make sure it is on.

Step 9:
All plugs have to be replaced by following the steps from 3 to 8.